translator
278
edits
Difference between revisions of "Swap"
Marked this version for translation
m (page translations: added some texts) |
(Marked this version for translation) |
||
| Line 118: | Line 118: | ||
sudo bash -c "echo UUID=$(lsblk -no UUID /dev/sda3) none swap defaults 0 0 >> /etc/fstab" | sudo bash -c "echo UUID=$(lsblk -no UUID /dev/sda3) none swap defaults 0 0 >> /etc/fstab" | ||
<translate>If you would like to have more than one swap partition, simply repeat the steps above for any additional partitions.</translate> | <translate><!--T:96--> If you would like to have more than one swap partition, simply repeat the steps above for any additional partitions.</translate> | ||
{{note|<translate>Be sure to replace /dev/sda3 in the above commands with your actual swap partition.</translate>}} | {{note|<translate><!--T:97--> Be sure to replace /dev/sda3 in the above commands with your actual swap partition.</translate>}} | ||
{{tip|<translate>''If you're using a HDD'' (spinning rust) put the swap partition *at the beginning of the disk* as the speed of the disk is higher on the inside tracks. On an SSD this doesn't matter.</translate>}} | {{tip|<translate><!--T:98--> ''If you're using a HDD'' (spinning rust) put the swap partition *at the beginning of the disk* as the speed of the disk is higher on the inside tracks. On an SSD this doesn't matter.</translate>}} | ||
<translate> | <translate> | ||
=Using a Swapfile= <!--T:39--> | =Using a Swapfile= <!--T:39--> | ||