8,560
edits
Difference between revisions of "Fstab - Use SystemD automount/en"
Updating to match new version of source page
(Updating to match new version of source page) |
(Updating to match new version of source page) |
||
| Line 20: | Line 20: | ||
Add the following to the beginning of the options section in your /etc/fstab, the numbers at the end are a time limit for how long it should try to make a connection before giving up & moving on: | Add the following to the beginning of the options section in your /etc/fstab, the numbers at the end are a time limit for how long it should try to make a connection before giving up & moving on: | ||
noauto,x-systemd.automount,x-systemd.device-timeout=10 | {{File|file=/etc/fstab|content=<pre>noauto,x-systemd.automount,x-systemd.device-timeout=10</pre>}} | ||
After I added the above to the following line in my fstab: | After I added the above to the following line in my fstab: | ||
192.168.1.15:/media-2 | {{File|file=/etc/fstab|content=<pre>192.168.1.15:/media-2 /mnt/NAS-media-2 nfs noauto,x-systemd.automount,x-systemd.device-timeout=10,timeo=14,hard,intr,noatime 0 0</pre>}} | ||
I could boot Manjaro whilst the ReadyNAS' Cat-6 network cable was unplugged, & there was NO noticeable delay. After the system was booted, I plugged the cable in & then called the NFS share /media-2 in Worker & it read the drive & listed the contents. | I could boot Manjaro whilst the ReadyNAS' Cat-6 network cable was unplugged, & there was NO noticeable delay. After the system was booted, I plugged the cable in & then called the NFS share /media-2 in Worker & it read the drive & listed the contents. | ||
| Line 33: | Line 35: | ||
If you have a very large /home & the boot process is held up when a scheduled fsck takes place (really not a big problem if you are using ext4), you can add the '''x-systemd.automount''' section to the options section of the line in your fstab for /home like so: | If you have a very large /home & the boot process is held up when a scheduled fsck takes place (really not a big problem if you are using ext4), you can add the '''x-systemd.automount''' section to the options section of the line in your fstab for /home like so: | ||
UUID=<id.number> /home noauto,x-systemd.automount,ext4 defaults 0 1 | {{File|file=/etc/fstab|content=<pre>UUID=<id.number> /home noauto,x-systemd.automount,ext4 defaults 0 1</pre>}} | ||
This will allow services that do not depend on /home to start while /home is checked by fsck. Mounting /home when it is first accessed, the kernel will buffer all file access to /home until it is ready.}} | This will allow services that do not depend on /home to start while /home is checked by fsck. Mounting /home when it is first accessed, the kernel will buffer all file access to /home until it is ready.}} | ||
[[Category:Contents Page{{#translation:}}]] | [[Category:Contents Page{{#translation:}}]] | ||