Difference between revisions of "Swap/de"

Updating to match new version of source page
(Updating to match new version of source page)
Tags: Mobile web edit Mobile edit
(Updating to match new version of source page)
Line 84: Line 84:
     read -n 1 -s -r -p "Press any key to continue"
     read -n 1 -s -r -p "Press any key to continue"
   else
   else
     echo "[warning] zwap not active. Continuing"
     echo "[warning] zswap not active. Continuing"
   fi
   fi
  else
  else
Line 92: Line 92:
   awk '/VmSwap|Name/{printf $2 "\t" $3}END{ print "" }' "$szFile"
   awk '/VmSwap|Name/{printf $2 "\t" $3}END{ print "" }' "$szFile"
  done | sort --key 2 --numeric --reverse | more
  done | sort --key 2 --numeric --reverse | more
=Eine Auslagerungspartition benutzen=
=Eine Auslagerungspartition benutzen=


Line 113: Line 114:


{{note|<span lang="en" dir="ltr" class="mw-content-ltr">Be sure to replace /dev/sda3 in the above commands with your actual swap partition.</span>}}
{{note|<span lang="en" dir="ltr" class="mw-content-ltr">Be sure to replace /dev/sda3 in the above commands with your actual swap partition.</span>}}
{{tip|<span lang="en" dir="ltr" class="mw-content-ltr">''If you're using a HDD'' (spinning rust) put the swap partition *at the beginning of the disk* as the speed of the disk is higher on the inside tracks. On an SSD this doesn't matter.</span>}}
{{tip|<span lang="en" dir="ltr" class="mw-content-ltr">''If you're using a HDD'' (spinning rust) put the swap partition *at the beginning of the disk* as the speed of the disk is higher on the outside tracks. On an SSD this doesn't matter.</span>}}


<div lang="en" dir="ltr" class="mw-content-ltr">
<div lang="en" dir="ltr" class="mw-content-ltr">
8,560

edits